On the Boot > Boot Priority menu, in the Legacy Boot Priority pane, Legacy Boot is disabled (unchecked).On the Devices and Peripherals > SATA menu, Chipset SATA Mode to AHCI.Press F9 to set all BIOS options to default values.Press F2 when prompted during boot to enter BIOS Setup.See the instructions at Install Windows 7* on Computers with USB 3.0.Ĭheck these BIOS settings (and change if necessary): Don't install Windows 10 on the Intel Optane Memory module.
If you plan to install both a hard drive and Intel® Optane™ Memory, Windows® 10 must be installed on the hard drive. If your Intel NUC model isn't listed in this table, there are no additional special instructions and you can proceed directly to the installation steps. See the table for special information you should know before you begin installing the operating system. Get your Windows image ready (purchased separately), on either a USB portable device or on a CD/DVD.Ĭlick or the topic for details: Model-specific information.Use another computer connected to the Internet to download the latest wired or wireless network driver for your Intel NUC.Install necessary components in the Intel NUC (memory and drive, purchased separately).Review the model-specific table below for any special information that applies to your Intel NUC model.Any help would be greatly appreciated.See the Supported Operating Systems for Intel® NUC Products for a list of Windows* versions supported by your Intel® NUC. Bottom line, I need to make the compact flash card bootable so I can run the Windows 98 setup. I then removed the floppy and restarted the desktop, but the desktop was not able to boot from the compact flash to IDE adapter, so I assume the NEC won't either. I booted the desktop off a Windows 98 boot and ran SYS C. The compact flash card is a 133x Transcend 8GB card. I connected the compact flash to IDE adapter internally to a desktop via my adapter.
I need to make the compact flash card bootable, but I haven't been successful in doing this. But without a floppy drive or optical drive, I have no way of doing this. Now I need to run the Windows 98 setup program to install Windows 98 onto the disk. I copied the Windows 98SE setup files to the compact flash card via my modern PC and a USB card reader. So I want to replace it with a Compact flash card via a Compact Flash to IDE adapter and install Windows 98SE. The hard drive doesn't sound very healthy, it clicks a lot. I did not come with the optical or floppy drive.
0 kommentar(er)
